Exam HPE6-A66 Realistic Dumps Verified Questions Free [Jan 18, 2024]
Valid HPE6-A66 Dumps for Helping Passing HP Exam!
NEW QUESTION # 17
A network architect is creating a new wireless solution for a customer. Wireless coverage is required throughout all four floors of two buildings on the same campus. Dynamic RF capabilities, including AirMatch, are required. Seamless roaming is required within and between the two buildings. Each floor will have approximately 20 APs and 6 external APs are required for connectivity between the two buildings.
- A. Two 7205 mobility controllers in a cluster
- B. Given this information, which Aruba solution would be the most cost-effective while still meeting the customer's requirements? O An IAP cluster per floor
- C. A standalone 7008 controller per floor
- D. Two 7030 mobility controllers in a cluster
Answer: B
NEW QUESTION # 18
A network architect needs to plan a new wireless network
- A. Airwave, Central, and Windows only
- B. Airwave and Central only
- C. Central only
- D. Airwave, Central, Windows, Mac OSX, and Linux
Answer: B
NEW QUESTION # 19
A customer requires a campus core virtualization solution that supports a dual control and management planes, as well as active-active forwarding paths. Which solution would meet the customer's requirements?
- A. Backplane stacking
- B. VSX
- C. Mesh stacking
- D. VSF
Answer: A
NEW QUESTION # 20
Which type of Aruba AP uses its radio as its back-haul connection?
- A. Mesh Point
- B. Air Monitor (AM)
- C. Mesh Porta
- D. Remote AP (RAP)
Answer: C
NEW QUESTION # 21
A customer currently has sets of three Aruba 5406R switches deployed for an access layer in multiple wiring closets in a building They are clustered in a VSF domain The customer wants to set up Multiple Active Detection (MAD) for the OOBM port, as well as use this port for remote management access. To simplify the connectivity, the customer wants to connect these three switches' OOBM ports to a separate switch in the wiring closet for the OOBM connectivity.
Which would be the most cost-effective solution that would meet the customer's requirements?
- A. 2930M
- B. 0
- C. 2930F
- D. 5406R
Answer: B
NEW QUESTION # 22
Which component uniquely defines the BSSID when implementing an employee SSID?
- A. Case-sensitive SSID name
- B. Radio MAC address
- C. Case-insensitive SSID name
- D. Wireless device MAC address
Answer: D
NEW QUESTION # 23
Which must you perform in IRIS to assign a device to a Design Group?
- A. Drag and drop the device into the Design Group
- B. Right-click the device and select Set Design Group
- C. Right-click the device and select Set Layer Membership
- D. Drag and drop the device into the Site
Answer: A
NEW QUESTION # 24
A network architect is designing a Wi-Fi solution for a customer using Aruba Central's VisualRF tool When creating a Campus view, how would the network architect pull in a map that displayed the campus location in a city?
- A. Create a screen capture from any web-based map site and import the picture file
- B. Import the longitude and latitude information from Google Maps
- C. Import the longitude and latitude information from any web-based map site
- D. Use VisualRF's built-in map tool and define the appropriate longitude and latitude information
Answer: C
NEW QUESTION # 25
A customer placed an order for an ArubaOS 5406R switch and plans to rack mount it in a wiring closet. The dimensions of the switch are 17.5 inches wide (44.45 cm), 6.9 inches high (17.5 cm), and 17.75 inches deep (45.1 cm). How many rack units should a customer plan for this switch?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 26
Which feature does the Aruba AP 387 support?
- A. 60GHZRF
- B. Indoor usage
- C. 802.11 ax
- D. included external directional antennas
Answer: A
NEW QUESTION # 27
NewStellar has a main corporate campus in a business park with two adjacent buildings that are 150 feet apart (46 meters). This is an open campus with no obstructions between the two buildings Each building has three floors and each floor is 322 x 175 feet (98 x 53 meters) for 56,350 square feet (5,235 square meters) total, which results in a total of 338,100 feet (31,410 square meters) for the entire building space. The ceiling for each floor is 12 feet (3.6 meters) high with a drop-down ceiling at 10 feet (3 meters) The network architect has given one floor to analyze. Building 1 Floor 2, shown in the attached exhibit.
This floor has a central main corridor with washrooms, stairs, elevators and supply, and network cabinets. There are cubicles around the perimeter of the floor. The central part main corridor's dimensions contain 9,350 square feet (870 square meters).
The company has determined that Wi-Fi coverage will not include the central area of each floor, which includes the washrooms, stairs, elevators and supply and network cabinets. Based on a capacity design, approximately how many APs should a network architect add to each floor to plan the design in VisuaiRF?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 28
A network architect is redesigning a wireless network. The architect begins by analyzing the number of spatial streams supported by APs of various vendors as well as the wireless devices currently in the network, if the company wants to ensure that new wireless design, including user wireless devices, support Multi-User MIMO (MU-MIMO). which standard or standards must the wireless products support?
- A. Only 802.11ax and 8011.ac
- B. Only 802.11ax,802.11ac, 802.11n, and 802.11a
- C. Only 802.11ax,802.1lac, and 802.l1n
- D. Only 802.11ax
Answer: C
NEW QUESTION # 29
NewStellar has a main corporate campus in a business park with two adjacent buildings. Each building has three floors and each floor is 322 x 175 feet (98 x 53 meters) for 56,350 square feet (5,235 square meters) total. The ceiling for each floor is 12 feet (3.6 meters) high with a drop-down ceiling at 10 feet (3 meters). The network architect has given you one floor to analyze, Building 1 Floor 2, shown in the attached exhibit.
This floor has a central main corridor with washrooms, stairs, elevators and supply and network cabinets. There are cubicles around the perimeter of the floor. The central part main corridor's dimensions contain 9,350 square feet (870 square meters). Assuming that wireless coverage is not required in the central area, which square footage (square meter) value should a network architect use when determining the number of APs in a capacity design for each floor?
- A. 338,100 feet {31,410 square meters)
- B. 47.000 square feet {4,365 square meters)
- C. 56.350 square feet {5,235 square meters)
- D. 55.750 square feet {5,175 square meters)
Answer: C
NEW QUESTION # 30
A customer is designing a new wired network. The customer requires 50 Gbps uplinks, VSF logical switching, and smart rate port support Which of the following switches would meet these requirements?
- A. 5400R series
- B. 8300 series
- C. 3810M series
- D. 6300 series
Answer: C
NEW QUESTION # 31
When determining a customer's agenda and clarifying their expectations for a new HPE/Aruba deployment, which two questions should be asked during the stakeholder checklist? (Select two.)
- A. What is your anticipated growth of the environment?
- B. What business problems are you trying to solve?
- C. is a request for proposal or actual bill of materials (BOM) required?
- D. Which help desk system is deployed?
- E. What is the networking experience of onsite personnel?
Answer: B,C
NEW QUESTION # 32
Refer to the exhibit.
When planning the use of Cat7 cabling for a SmartRate connection between an ArubaOS AP and an ArubaOS switch, which sections should be considered when calculating distance?
- A. A + C
- B. A + B + C
- C. A + B
- D. A + B + C + D
Answer: D
NEW QUESTION # 33
A network architect has created two sites in IRIS and defined network devices for each site. From which window would a network architect connect the two sites together?
- A. Topology
- B. Start Page
- C. Catalog
- D. Site-1
Answer: D
NEW QUESTION # 34
A network architect is given the task to design a new network solution for NewStellar Company, Inc. NewSteiiar has a main corporate campus in a business park with two adjacent buildings. The network architect has given one floor to analyze, Building 1 Floor 2, shown in the attached exhibit.
Each building has three floors and each floor is 322 x 175 feet (98 x 53 meters) for 56,350 square feet (5,235 square meters) total, which results in a total of 338,100 feet (31,410 square meters) for the entire building space. Each floor has a central main corridor with washrooms, stairs, elevators and supply and network cabinets. There are cubicles around the perimeter of the floor. The central part main corridor's dimensions contain 9,350 square feet {870 square meters).
Because of security concerns, video cameras will be installed throughout the facility. There are 16 of these per floor, 8 per wiring closet. The cameras are non-WiFi capable and require POE 802.3af-capable switch ports from which to draw power.
A wireless capacity design is required. Assuming that wireless coverage is required across the Building 1, Floor 2, including the central area, and that half the required APs will connect to each wiring closet, approximately how many POE+ ports will be required per wiring closet for all devices that have POE or POE+ needs?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 35
A network architect is designing a new Wi-Fi solution for a customer The customer currently occupies a one-story building on a small campus. In one part of the building there is an auditorium, where the ceiling height and attenuation is different from the rest of the building. What should the network architect create in VisualRF to identify this difference when planning :ne APs?
- A. Define the appropriate properties in the Network View
- B. Define the appropriate properties in the Building View
- C. Create a Region in the Floorplan View
- D. Spit the Building View into two Floorplan Views
Answer: B
NEW QUESTION # 36
......
The HP HPE6-A66 exam covers a range of topics, including network architecture design, security, and mobility. It also covers the design considerations for different types of environments, such as indoor and outdoor spaces, as well as remote and branch offices. HPE6-A66 exam is designed to test the candidate's ability to design, plan, and implement Aruba wireless networks that meet the needs of different organizations.
HPE6-A66 Exam Dumps For Certification Exam Preparation: https://www.actualtestsquiz.com/HPE6-A66-test-torrent.html
Download Free HP HPE6-A66 Exam Questions & Answer : https://drive.google.com/open?id=1oWT74e2Fs0ckmnQq7sgwTUgfGPzckxrp
