Pass with professional 300-110 actual quiz materials

Cisco 300-110 Exam Overview:

Cisco 300-110 Exam Syllabus Topics:

Cisco Designing Cisco Wireless Networks Sample Questions:

Question 1

An engineer must assess an existing company WLAN to determine the possibility for future IEEE
802.11ac Wave 2 wireless deployment. All access switches are Fast Ethernet-capable only, and the wired infrastructure between existing APs and access switches is based on the CAT 6A standard. Which two actions provide maximum support of Cisco 3800 Series access points?
(Choose two.)

A. Replace the existing switches with mGig switches.
B. Replace the existing switches with gigabit switches with 10G uplinks.
C. Ensure that cable distances between access switches and APs are not longer than 55 meters.
D. Replace the existing wiring infrastructure with the CAT-7E wiring standard.
E. Ensure that cable distances between access switches and APs are not longer than 100 meters.

Question 2

An enterprise is using two wireless controllers to support the wireless network. The data centre is located in the head office. Each controller has a corporate WLAN configured with different SSID names. The APs are installed using a round-robin approach to load balance the traffic. What should be changed in the configuration to optimize roaming?

A. Use the same WLAN name for the corporate network on both controllers.
B. Use the same WLAN name for the corporate network on both controllers.
C. Place the access points per floor on the same controller.
D. Move all access points to one controller and use the other as N+1 HA.

Question 3

A campus has two controllers, each with client VLANs on different subnets. A client associated to an AP on WLC-1 roams to an AP on WLC-2. Which behavior does the mobility design produce, and what is required?

A. A Layer 3 roam occurs; the client must obtain a new IP address from WLC-2.
B. A Layer 2 roam occurs; no mobility configuration is required.
C. The client is deauthenticated and must reauthenticate from the beginning.
D. A Layer 3 roam occurs; the client keeps its IP address through an asymmetric tunnel from the anchor to the foreign controller.

Question 4

An engineer is designing a point-to-point outdoor bridge link spanning 4 km between two buildings. Which two factors must be calculated during the design? (Choose two.)

A. link budget including antenna gain, cable loss, and receiver sensitivity
B. CAPWAP control plane MTU
C. mobility group name consistency at both ends
D. 60% Fresnel zone clearance along the path
E. DHCP scope size at the remote building

Question 5

An engineer is designing a high-density WLAN that must support 100 concurrent users with 100 Mbps throughput consistently. The design allows for 20 Mbps per cell and per channel on the 5 GHz band. How many channels must the design use to provide 1 Mbps per user prior to RF overhead?

A. 20
B. 10
C. 5
D. 15

Solutions: