Pass with professional NSE7_FSN_AR-7.6 actual quiz materials

Fortinet NSE7_FSN_AR-7.6 Exam Overview:

Fortinet NSE7_FSN_AR-7.6 Exam Syllabus Topics:

Fortinet NSE 7 - Secure Networking 7.6 Architect Sample Questions:

1. Refer to the exhibit, which shows the output of diagnose sys session list.

If the HA ID for the primary device is 0, what happens if the primary fails and the secondary becomes the primary?

A) The session will be removed from the session table of the secondary device because of the presence of allowed error packets, which will force the client to restart the session with the server.
B) The session state is preserved but the kernel will need to re-evaluate the session because NAT was applied.
C) Traffic for this session continues to be permitted on the new primary device after failover, without requiring the client to restart the session with the server.
D) The secondary device has this session synchronized; however, because application control is applied, the session is marked dirty and has to be re-evaluated after failover.

2. Refer to the exhibit.

The sniffer log on two FortiGate devices are shown. Based on the information in the log, which two factors explain the output on FortiGate FGT-02? (Choose two answers)

A) The administrator configured the wrong remote peer IP address on FGT-01.
B) A third-party device is blocking protocol 50.
C) The administrator set the wrong sniffer filter on FGT-02.
D) The administrator has not yet configured the VPN tunnel on FGT-02.

3. You configure the overlay tunnels for an SD-WAN hub-and-spoke topology defined with IPsec tunnels, BGP on loopback, and dynamic BGP.
Which two are recommended IPsec settings for this topology? (Choose two answers.)

A) On the hub, set the tunnel type to static.
B) On the spoke, configure the parameter localid.
C) On the spoke, set the parameter net-device to enable.
D) On the hub, set the parameter mode-cfg to enable.

4. Refer to the exhibit, which shows a partial output from the get router info routing-table database command.

The administrator wants to configure a default static route for port3 and assign a distance of 50 and a priority of 0.
What will happen to the port1 and port2 default static routes after the port3 default static route is created?

A) The port2 default static route will be injected into the forwarding information base (FIB).
B) Both default static routes shown in the output will be injected into the FIB.
C) Neither of the routes shown in the output will be injected into the FIB.
D) The port1 default static route will be injected into the FIB.

5. Refer to the exhibit, which shows a session entry.

Which statement about this session is true?

A) It is an ICMP session from 10.1.10.1 to 10.200.5.1.
B) It is an ICMP session from 10.1.10.10 to 10.200.1.1.
C) Return traffic to the initiator is sent lo 10.200.1.254.
D) Return traffic to the initiator is sent to 10.1.0.1.

Solutions: